CLEAN & CLUTTER-FREE
Designed with special aluminum extrusions that are Built To
Last for both framed or unframed acrylic or fiberglass door
systems.
FORGIVING GLIDE SYSTEM WITH
THESE FEATURES:
Door slides easily even if the door or track is twisted.
Glides work like a cylinder within a cylinder so that the
glides center themselves in the track and can rotate around
the track to compensate for misalignment. The glides have
unique 45° thrust bars that take side loads that are common
with Companionway doors that are formed at 90°.
 ALUMINUM EXTRUSIONS CAP THE
TOP AND BOTTOM OF THE DOOR
They enclose the glides to minimize the problems with dirt
being kicked into them. The glides also
tend to shed dirt.
The extrusions form a labyrinth seal that seals the top and
bottom of the door from rain and dirt.
The Slide Extrusion is two pieces and sandwiches the acrylic
or fiberglass. The acrylic is slotted so the door can be
adjusted to the boat surface. This provides a tight grip to
lock down on the acrylic and it also stiffens the top and
bottom of the door.
The Slide and rail can be mounted horizontally and vertically.
There are recessed slots in the slide for easy mounting of the
door system.
 EASIER
INSTALLATION
The assemblies are easy to install due to their uniformity
because both the acrylic and the metal parts are CNC machined.
Unique female fasteners that are almost invisible on the clamp
bar allow stainless steel flat head screws to be used to
tighten the extrusions down on the acrylic. Serrations—both on
the clamp bar and rail—lock the acrylic in place after
installation adjustments. Our door system is so unique it is
patented.
EASY FIELD REPLACEMENT OF DOOR
The acrylic door can be removed without removing the slides
and rails or the frame by loosening
the screws on the clamp bar from the back.
 BUILT-IN
STOPS
There is a unique open door stop that is attached to the
slide. It pivots into position to hold the door open and it
pivots out of the way to let the door pass. It can be mounted
on the top slide so there is no more bending down to put the
stop in place and no more stepping on the doorstop. An end
stop is held on the slide with screws and can be removed.
PATENT # 6.131.340
 SEE
OUR NEW ELECTRIC DOOR TRACK!
|
